Assembly Instructions OG 12v Fridge V2 (Nov 23 onwards)

***Test first with water to ensure all fittings are secure***
Package Contents
  • Camp Keg OG 
  • Mini Tap
  • Mounting Kit
  • Mini 360 Core Actuator CO2 Regulator
  • Gas and Liquid line
  • Connections
  • Keg

Assembly Instructions

Step 1: Attaching the Tap System

Put auto close spring into tap with the small side facing outwards.

Push beer line through opening and attach to the back of your mini tap.

Hold collar and twist in black Mini tap, making sure to tighten all the way.

    Step 2: Attach a compatible CO2 cylinder to the regulator and secure it in place.

    Here's a great video explanation:  here

    Remove the female threaded gas joiner by unscrewing the small side screw and replace with the 6.5mm barb (if not done already)

    Push the 6.5 mm joiner onto the 6.5mm barb. Push the line firmly into the joiner. If it is a non return valve joiner the arrow must be pointing away from the regulator and towards the keg. 

    Unscrew the reducing bush on the inlet (this can be used for the small CO2 bulbs). Screw the Sodatream compatible cylinder into the regulator, making sure to hold the neck of the cylinder in place while attaching and detaching. Screw the thumb screw in to depress the valve on the cylinder. Ensure a seal is formed between the cylinder and the regulator. Tighten more if needed but do not over tighten the cylinder into the reducing bush. Over tightening can result in no gas being able to pass through the regulator. Perform a leak test to ensure an adequate seal has been formed.

    Attach the gas (grey & red) quick connect onto the line and the grooved ball lock tab on the keg.

    Attach the (black & yellow) liquid line to the non grooved ball lock tab on the keg (if not done already)

    Here's a great video on the connections here

    After this is done, you will just need to take your quick connects off to fill your keg up with beer/cider/cocktails and then set your PSI and you will be good to go!

    Step 3: Setting the Regulator

    Adjust the regulator to your desired PSI for perfect dispensing. Depending on what your pouring will depend on your PSI! If you are pouring beer we suggest you start low (2) and work your way up in order not to waste any beer. 10-12 psi is the sweet spot at 3-5 degrees!  If you are doing cocktails they are pretty forgiving so start around 10 and work your way up!

    Step 4: Checking Seals and Connections

    Ensure all seals and connections are tight to prevent any leaks. We recommend to run the whole system with water just to make sure no parts have come loose in transit!

     

    Operating Instructions

    Dispensing Your Chilled Beverage

    Pull the tap handle gently to start dispensing. Adjust pressure as needed for a perfect pour.

    Depending on what your pouring will depend on your PSI! If you are pouring beer, we suggest you start low (2) and work your way up in order not to waste any beer. 10-12 psi is the sweet spot at 3-5 degrees!  If you are doing cocktails, they are pretty forgiving so start around 10 and work your way up!

    Maintenance and Cleaning

    After use, empty any remaining liquid and wipe down and wash the keg with an approved wash solution. Rinse the tap and line system thoroughly.

    Troubleshooting

    For any issues, refer to our Troubleshooting Guide included on our website!

    Safety Precautions

    Keep out of reach of children.

    OG V1 12v/240v Fridge Specifications